PrevPrev Go to previous topic
NextNext Go to next topic
Last Post 15 Jul 2019 08:50 AM by  Mari Minari
Stitching together photos of open water in OneButton?
 1 Replies
Sort:
You are not authorized to post a reply.
Author Messages

David Hicks



New Member


Posts:
New Member


--
10 Jul 2019 01:31 PM
    Hi, I have over 800 aerial photos (and will eventually have more) that I am trying to stitch together in OneButton. The photos are of an estuary and every time I try to stitch them together in OneButton it fails to stitch the "open water" photos together. It does fine stitching the photos of water near the shoreline, but it will not process the images out in the middle of the estuary. Is this common, and if so, is there a way to change settings so that it will stitch photos together based only on the geotag? Thank you in advance!

    Mari Minari



    Veteran Member


    Posts:2313
    Veteran Member


    --
    15 Jul 2019 08:50 AM
    While I have not worked with many UAV photos that cover mostly water, I believe these images would pose a problem because of the orthomosaic process. The process involves finding tie points between images and image matching (correlation) of objects and features it can find between overlapping images. Water has little, if any, of this information so may prove difficult to process.
    You are not authorized to post a reply.